Configuration and Image File Commands
OL-32830-01 Command Line Interface Reference Guide
•
ipv6_address
%
specified.
•
ipv6_address
%0 - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
•
ipv6_address
an IPv6 address is defined.
Invalid Combinations of Source and Destination
The following are invalid combinations of source and destination files:
•
The source file and destination file are the same file.
•
xmodem: is the destination file. The source file can be copied to image,
boot and null: only.
•
tftp:// is the source file and destination file on the same copy.
•
*.prv files cannot be copied.
•
mirror-config cannot be used as a destination
The following table describes the characters displayed by the system when copy
is being run:
Character
Description
!
For network transfers, indicates that the copy process
is taking place. Each exclamation point indicates
successful transfer of ten packets (512 bytes each).
.
For network transfers, indicates that the copy process
timed out.
Various Copy Options Guidelines
•
Copying an Image File from a Server to Flash Memory
source-url
Use the copy
a server to flash memory. When the administrator copies an image file from
the server to a device, the image file is saved to the "inactive" image. To use
this image, the administrator must switch the inactive image to the active
image and reboot. The device will then use this new image.
•
Copying a Boot File from a Server to Flash Memory
•
source-url
Use the copy
flash memory. Copying a Configuration File from a Server to the Running
Configuration File
interface_id
- Refers to the IPv6 address on the interface
- Refers to the IPv6 address on the single interface on which
flash://image command to copy an image file from
boot command to copy a boot file from a server to
10
256