Ipv6 Dhcp Relay Destination (Global) - Cisco 300 Series Cli Manual

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Example 2. The following sets the DIID-EN format using colons as delimiter:

switchxxxxxx(config)#

14.6 ipv6 dhcp relay destination (Global)

To specify a globally-defined relay destination address to which client messages

are forwarded, use the ipv6 dhcp relay destination command in global

configuration mode. To remove a relay destination address, use the no form of this

ipv6 dhcp relay destination {

no ipv6 dhcp relay destination [{

ipv6-address

documented in RFC 4291 where the address is specified in hexadecimal

using 16-bit values between colons. There are the following types of relay

destination address:

Link-local Unicast address. A user must specify the

argument for this kind of address.

Global Unicast IPv6 address. If the

the Routing table is used.

interface-id

—Interface identifier that specifies the output interface for a

destination. If this argument is configured, client messages are forwarded to

the well-known link-local Multicast address

All_DHCP_Relay_Agents_and_Servers (FF02::1:2) through the link to which

the output interface is connected.

Default Configuration

There is no globally-defined relay destination.

Command Mode

Global Configuration mode

ipv6 dhcp udid-en 9 0C:C0:84:D3:03:00:09:12

ipv6-address

interface-id

]—Relay destination IPv6 address in the form

OL-32830-01 Command Line Interface Reference Guide

interface-id

interface-id

interface-id

argument is omitted then

DHCPv6 Commands