Flowcontrol - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Ethernet Configuration Commands
OL-32830-01 Command Line Interface Reference Guide
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example enables auto-negotiation on gi 1 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
18.9 flowcontrol
To configure the Flow Control on a given interface, use the flowcontrol Interface
(Ethernet, Port Channel) Configuration mode command. To disable Flow Control,
use the no form of this command.
Syntax
{auto | on | off}
flowcontrol
no flowcontrol
Parameters
•
auto—Specifies auto-negotiation of Flow Control.
•
on—Enables Flow Control.
•
off—Disables Flow Control.
Default Configuration
Flow control is Disabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
Use the negotiation command to enable flow control auto.
interface gi11
negotiation
18
396
Advertisement
Table of Contents
