Cisco 300 Series Cli Manual page 451

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

—Specifies the network mask of the IP address.

prefix-length

—Specifies the number of bits that comprise the IP address

prefix. The prefix length must be preceded by a forward slash (/). (Range:

default-gateway-ip-address

The route is gotten a metric of 1.

Default Configuration

No IP address is defined for interfaces.

Command Mode

Interface Configuration mode

User Guidelines

Use the ip address command to define a static IP address on an interface.

In router mode.

Multiple IP addresses are supported. A new defined IP address is added on the

Defining a static IP address on an interface stops a DHCP client running on the

interface and removes the IP address assigned by the DHCP client.

If a configured IP address overlaps another configured one a warning message is

displayed. To change an existed IP address, delete the existed one and add the

In switch mode.

One IP address is supported. A new defined IP address overrides the previously

defined IP address.

Defining a static IP address stops a running DHCP client and deletes the IP

address assigned by the DHCP client.

While no IP address is assigned either by DHCP client or manually the default IP

address 192.168.1.254 is assigned on the Default VLAN.

Example 1. The following example configures VLAN 1 with IP address

131.108.1.27 and subnet mask 255.255.255.0.

—Specifies the default gateway IP address.

OL-32830-01 Command Line Interface Reference Guide

IP Addressing Commands