Cisco 300 Series Cli Manual page 475

Stackable managed switches

Hide thumbs Also See for 300 Series:

Table of Contents

Default Usage

Command Mode

Privileged EXEC mode

User Guidelines

Press Esc to stop pinging. Following are sample results of the ping command:

Destination does not respond—If the host does not respond, a "no answer

from host" appears within 10 seconds.

Destination unreachable—The gateway for this destination indicates that

the destination is unreachable.

Network or host unreachable—The switch found no corresponding entry in

the route table.

When using the ping ipv6 command to check network connectivity of a directly

attached host using its link local address, the egress interface may be specified in

the IPv6Z format. If the egress interface is not specified, the default interface is

When using the ping ipv6 command with a Multicast address, the information

displayed is taken from all received echo responses.

When the source keyword is configured and the source address is not an address

of the switch, the command is halted with an error message and pings are not

Example 1 - Ping an IP address.

switchxxxxxx> ping ip 10.1.1.1

Pinging 10.1.1.1 with 64 bytes of data:

64 bytes from 10.1.1.1: icmp_seq=0. time=11 ms

64 bytes from 10.1.1.1: icmp_seq=1. time=8 ms

64 bytes from 10.1.1.1: icmp_seq=2. time=8 ms

64 bytes from 10.1.1.1: icmp_seq=3. time=7 ms

----10.1.1.1 PING Statistics----

4 packets transmitted, 4 packets received, 0% packet loss

IP System Management Commands

OL-32830-01 Command Line Interface Reference Guide