Lldp Notifications Interval - Cisco 300 Series Cli Manual
Stackable managed switches
Hide thumbs
Also See for 300 Series:
- Cli manual (899 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
30
657
Default Configuration
Disabled.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP notifications on gi 1 1.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
30.14 lldp notifications interval
To configure the maximum transmission rate of LLDP notifications, use the lldp
notifications interval Global Configuration mode command. To return to the default,
use the no form of this command.
Syntax
lldp notifications interval
no lldp notifications interval
Parameters
seconds
interval
—The device does not send more than a single notification in the
indicated period (range: 5–3600).
Default Configuration
5 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#
Link Layer Discovery Protocol (LLDP) Commands
interface gi11
lldp notifications enable
seconds
lldp notifications interval 10
OL-32830-01 Command Line Interface Reference Guide
Advertisement
Table of Contents
