Dot1X Timeout Server-Timeout - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
22
328
Example
The following example sets the time interval during which the device waits for a
response to an EAP request frame from the client before resending the request to
3600 seconds.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
22.11 dot1x timeout server-timeout
Use the dot1x timeout server-timeout Interface Configuration (Ethernet) mode
command to set the time interval during which the device waits for a response
from the authentication server. Use the no form of this command to restore the
default configuration.
Syntax
dot1x timeout server-timeout
no dot1x timeout server-timeout
Parameters
seconds
server-timeout
device waits for a response from the authentication server. (Range: 1–65535
seconds)
Default Configuration
The default timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The actual timeout period can be determined by comparing the value specified by
the dot1x timeout server-timeout command to the result of multiplying the number
of retries specified by the
period specified by the
lower of the two values.
interface gi15
dot1x timeout supp-timeout
seconds
—Specifies the time interval in seconds during which the
radius-server retransmit
radius-server retransmit
78-21075-01 Command Line Interface Reference Guide
802. 1 X Commands
3600
command by the timeout
command, and selecting the
Advertisement
Table of Contents
