Dot1X Timeout - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
dot1x timeout
Syntax Description
Defaults
Command Modes
OL-21522-02
Downloaded from
www.Manualslib.com
Use the dot1x timeout interface configuration command on the switch stack or on a standalone switch
to set IEEE 802.1x timers. Use the no form of this command to return to the default setting.
dot1x timeout {quiet-period seconds | ratelimit-period seconds | reauth-period {seconds |
server} | server-timeout seconds | supp-timeout seconds | tx-period seconds}
no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period}
quiet-period seconds
ratelimit-period seconds Number of seconds that the switch ignores Extensible Authentication
reauth-period {seconds |
server}
server-timeout seconds
supp-timeout seconds
tx-period seconds
These are the default settings:
reauth-period is 3600 seconds.
quiet-period is 60 seconds.
tx-period is 5 seconds.
supp-timeout is 30 seconds.
server-timeout is 30 seconds.
rate-limit is 1 second.
Interface configuration
manuals search engine
Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
Protocol over LAN (EAPOL) packets from clients that have been
successfully authenticated during this duration. The range is 1 to 65535.
Set the number of seconds between re-authentication attempts.
The keywords have these meanings:
•
seconds—Sets the number of seconds from 1 to 65535; the default is
3600 seconds.
•
server—Sets the number of seconds as the value of the
Session-Timeout RADIUS attribute (Attribute[27]).
Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server.
The range is 1 to 65535. However, we recommend a minimum setting
of 30.
Number of seconds that the switch waits for the retransmission of packets
by the switch to the IEEE 802.1x client. The range is 30 to 65535.
Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the
request. The range is 1 to 65535.
Catalyst 3750-X and 3560-X Switch Command Reference
dot1x timeout
2-185
Advertisement
Table of Contents
