Nsf - Cisco Catalyst 3560-X Command Reference Manual

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

nsf

Syntax Description

Command Modes

Command History

Usage Guidelines

Downloaded from

www.Manualslib.com

Use the nsf router configuration command on a switch stack or standalone switch to enable and configure

Cisco nonstop forwarding (NSF) for Open Shortest Path First (OSPF) or Enhanced Interior Gateway

Routing Protocol (EIGRP) routing. Use the no form of this command to disable NSF.

nsf [enforce global]

This command is not supported on switches running the LAN base feature set.

enforce global

NSF is disabled.

The enforce global option is enabled (OSPF only).

Router configuration (OSPF or EIGRP)

The nsf command is a router configuration command and affects all interfaces that are covered by the

designated routing process. The switch supports Cisco NSF for OSPF and EIGRP protocols.

When NSF is enabled and a stack master switchover is detected, the NSF-capable routers rebuild routing

information from NSF-aware or NSF-capable neighbors and do not wait for a restart.

This example shows how to enable OSPF NSF:

Switch(config)# router ospf 100

Switch(config-router)# nsf

Use the show ip ospf privileged EXEC command to verify that OSPF NSF is enabled.

This example shows how to enable EIGRP NSF:

Switch(config)# router eigrp 1

Switch(config-router)# nsf

Use the show ip protocols privileged EXEC command to verify that EIGRP NSF is enabled.

manuals search engine

(Optional) Cancel OSPF NSF restart when non-NSF-aware neighbors are

detected. These keywords are visible only in OSPF router configuration

Modification

This command was introduced.

Catalyst 3750-X and 3560-X Switch Command Reference

Catalyst 3750-x