Cisco Catalyst 3560-X Command Reference Manual page 899

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

Related Commands

Downloaded from

www.Manualslib.com

This example shows how to cause an interface to cease operating as a Layer 2 port and become a

Cisco-routed port:

Switch(config-if)# no switchport

This example shows how to cause the port interface to cease operating as a Cisco-routed port and convert

to a Layer 2 switched interface:

Switch(config-if)# switchport

The switchport command without keywords is not used on platforms that do not support Cisco-routed

ports. All physical ports on such platforms are assumed to be Layer 2-switched interfaces.

You can verify the switchport status of an interface by entering the show running-config privileged

EXEC command.

show interfaces

switchport Displays the administrative and operational status of a switching

show running-config

manuals search engine

(nonrouting) port, including port blocking and port protection settings.

Displays the operating configuration. For syntax information, use this

link to the Cisco IOS Release 12.2 Command Reference listing page:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_com

mand_reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to

navigate to the command.

Catalyst 3750-X and 3560-X Switch Command Reference

Catalyst 3750-x