Debug Platform Sw-Bridge - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Appendix B
Catalyst 3750-X and 3560-X Switch Debug Commands
debug platform sw-bridge
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Related Commands
OL-21522-02
Downloaded from
www.Manualslib.com
Use the debug platform sw-bridge privileged EXEC command to enable debugging of the software
bridging function. Use the no form of this command to disable debugging.
debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
no debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
broadcast
Display broadcast-data debug messages.
control
Display protocol-packet debug messages.
multicast
Display multicast-data debug messages.
packet
Display sent and received data debug messages.
unicast
Display unicast-data debug messages.
Debugging is disabled.
Privileged EXEC
Release
12.2(53)SE2
The undebug platform sw-bridge command is the same as the no debug platform sw-bridge
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command
show debugging
manuals search engine
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform sw-bridge
B-75
Advertisement
Table of Contents
