Show Dot1Q-Tunnel - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
show dot1q-tunnel
show dot1q-tunnel
Note
Syntax Description
Command Modes
Command History
Usage Guidelines
Examples
Catalyst 3750-X and 3560-X Switch Command Reference
2-560
Downloaded from
www.Manualslib.com
Use the show dot1q-tunnel user EXEC command to display information about IEEE 802.1Q tunnel
ports.
show dot1q-tunnel [interface interface-id] [ | {begin | exclude | include} expression]
This command is not supported on switches running the LAN base feature set.
interface interface-id
(Optional) Specify the interface for which to display IEEE 802.1Q tunneling
information. Valid interfaces include physical ports and port channels.
| begin
(Optional) Display begins with the line that matches the expression.
| exclude
(Optional) Display excludes lines that match the expression.
| include
(Optional) Display includes lines that match the specified expression.
expression
Expression in the output to use as a reference point.
User EXEC
Release
Modification
12.2(53)SE2
This command was introduced.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
These are examples of output from the show dot1q-tunnel command:
Switch> show dot1q-tunnel
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Gi1/0/6
Po2
Switch> show dot1q-tunnel interface gigabitethernet1/0/1
dot1q-tunnel mode LAN Port(s)
-----------------------------
Gi1/0/1
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02
Advertisement
Table of Contents
