Cisco Catalyst 3560-X Command Reference Manual page 570
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
show controllers ethernet-controller
Table 2-29
Transmit Field Descriptions (continued)
Field
5 collision frames
6 collision frames
7 collision frames
8 collision frames
9 collision frames
10 collision frames
11 collision frames
12 collision frames
13 collision frames
14 collision frames
15 collision frames
Excessive collisions
Late collisions
VLAN discard frames
Excess defer frames
64 byte frames
127 byte frames
255 byte frames
511 byte frames
1023 byte frames
1518 byte frames
Too large frames
Good (1 coll) frames
1. CFI = Canonical Format Indicator
Table 2-30
Receive Field Descriptions
Field
Bytes
Unicast frames
Multicast frames
Broadcast frames
Catalyst 3750-X and 3560-X Switch Command Reference
2-538
Downloaded from
www.Manualslib.com
Description
The number of frames that are successfully sent on an interface after five collisions occur.
The number of frames that are successfully sent on an interface after six collisions occur.
The number of frames that are successfully sent on an interface after seven collisions occur.
The number of frames that are successfully sent on an interface after eight collisions occur.
The number of frames that are successfully sent on an interface after nine collisions occur.
The number of frames that are successfully sent on an interface after ten collisions occur.
The number of frames that are successfully sent on an interface after 11 collisions occur.
The number of frames that are successfully sent on an interface after 12 collisions occur.
The number of frames that are successfully sent on an interface after 13 collisions occur.
The number of frames that are successfully sent on an interface after 14 collisions occur.
The number of frames that are successfully sent on an interface after 15 collisions occur.
The number of frames that could not be sent on an interface after 16 collisions occur.
After a frame is sent, the number of frames dropped because late collisions were detected while the
frame was sent.
The number of frames dropped on an interface because the CFI
The number of frames that are not sent after the time exceeds the maximum-packet time.
The total number of frames sent on an interface that are 64 bytes.
The total number of frames sent on an interface that are from 65 to 127 bytes.
The total number of frames sent on an interface that are from 128 to 255 bytes.
The total number of frames sent on an interface that are from 256 to 511 bytes.
The total number of frames sent on an interface that are from 512 to 1023 bytes.
The total number of frames sent on an interface that are from 1024 to 1518 bytes.
The number of frames sent on an interface that are larger than the maximum allowed frame size.
The number of frames that are successfully sent on an interface after one collision occurs. This value
does not include the number of frames that are not successfully sent after one collision occurs.
Description
The total amount of memory (in bytes) used by frames received on an interface, including the
1
FCS
value and the incorrectly formed frames. This value excludes the frame header bits.
The total number of frames successfully received on the interface that are directed to unicast
addresses.
The total number of frames successfully received on the interface that are directed to multicast
addresses.
The total number of frames successfully received on an interface that are directed to broadcast
addresses.
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
1
bit is set.
OL-21522-02
Advertisement
Table of Contents
