Duplex - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
duplex
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
OL-21522-02
Downloaded from
www.Manualslib.com
Use the duplex interface configuration command on the switch stack or on a standalone switch to specify
the duplex mode of operation for a port. Use the no form of this command to return the port to its default
value.
duplex {auto | full | half}
no duplex
auto
Enable automatic duplex configuration; port automatically detects whether it
should run in full- or half-duplex mode, depending on the attached device mode.
full
Enable full-duplex mode.
half
Enable half-duplex mode (only for interfaces operating at 10 or 100 Mb/s). You
cannot configure half-duplex mode for interfaces operating at 1000 or
10,000 Mb/s.
The default is auto for Gigabit Ethernet ports.
You cannot configure the duplex mode on 10-Gigabit Ethernet ports; it is always full.
Duplex options are not supported on the 1000BASE-x (where -x is -BX, -CWDM, -LX, -SX, or -ZX)
SFP modules.
The default is half for 100BASE-x (where -x is -BX, -FX, -FX-FE, or - LX) small form-factor pluggable
(SFP) modules.
For information about which SFP modules are supported on your switch, see the product release notes.
Interface configuration
Release
12.2(53)SE2
For Fast Ethernet ports on stack members other than Catalyst 3750-X switches, setting the port to auto
has the same effect as specifying half if the attached device does not autonegotiate the duplex parameter.
For Gigabit Ethernet ports, setting the port to auto has the same effect as specifying full if the attached
device does not autonegotiate the duplex parameter.
Half-duplex mode is supported on Gigabit Ethernet interfaces if the duplex mode is auto and the
Note
connected device is operating at half duplex. However, you cannot configure these interfaces to
operate in half-duplex mode.
Certain ports can be configured to be either full duplex or half duplex. Applicability of this command
depends on the device to which the switch is attached.
manuals search engine
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
duplex
2-189
Advertisement
Table of Contents
