Ip Igmp Profile - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
ip igmp profile
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
OL-21522-02
Downloaded from
www.Manualslib.com
Use the ip igmp profile global configuration command on the switch stack or on a standalone switch to
create an Internet Group Management Protocol (IGMP) profile and enter IGMP profile configuration
mode. From this mode, you can specify the configuration of the IGMP profile to be used for filtering
IGMP membership reports from a switchport. Use the no form of this command to delete the IGMP
profile.
ip igmp profile profile number
no ip igmp profile profile number
profile number
The IGMP profile number being configured. The range is 1 to 4294967295.
No IGMP profiles are defined. When configured, the default action for matching an IGMP profile is to
deny matching addresses.
Global configuration
Release
12.2(53)SE2
When you are in IGMP profile configuration mode, you can create the profile by using these commands:
•
deny: specifies that matching addresses are denied; this is the default condition.
exit: exits from igmp-profile configuration mode.
•
•
no: negates a command or resets to its defaults.
permit: specifies that matching addresses are permitted.
•
range: specifies a range of IP addresses for the profile. This can be a single IP address or a range
•
with a start and an end address.
When entering a range, enter the low IP multicast address, a space, and the high IP multicast address.
You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one
profile applied to it.
This example shows how to configure IGMP profile 40 that permits the specified range of IP multicast
addresses:
Switch(config)# ip igmp profile 40
Switch(config-igmp-profile)# permit
Switch(config-igmp-profile)# range 233.1.1.1 233.255.255.255
You can verify your settings by using the show ip igmp profile privileged EXEC command.
manuals search engine
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
ip igmp profile
2-259
Advertisement
Table of Contents
