Cisco Catalyst 3560-X Command Reference Manual page 576
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
show controllers ethernet-controller fastethernet
Examples
Catalyst 3750-X and 3560-X Switch Command Reference
2-544
Downloaded from
www.Manualslib.com
This is an example of output from the show controllers ethernet-controller fastethernet 0 command.
See
Table 2-29
and
Table 2-30
Switch> show controller ethernet-controller fastethernet 0
Transmit FastEthernet0
5925 Bytes
0 Unicast frames
15 Multicast frames
1 Broadcast frames
0 Too old frames
0 Deferred frames
0 MTU exceeded frames
0 1 collision frames
0 2 collision frames
0 3 collision frames
0 4 collision frames
0 5 collision frames
0 6 collision frames
0 7 collision frames
0 8 collision frames
0 9 collision frames
0 10 collision frames
0 11 collision frames
0 12 collision frames
0 13 collision frames
0 14 collision frames
0 15 collision frames
0 Excessive collisions
0 Late collisions
0 VLAN discard frames
0 Excess defer frames
0 64 byte frames
0 127 byte frames
0 255 byte frames
0 511 byte frames
0 1023 byte frames
0 1518 byte frames
0 Too large frames
0 Good (1 coll) frames
0 Good (>1 coll) frames
This is an example of output from the show controllers ethernet-controller fastethernet 0 phy
command on a switch:
Switch# show controller ethernet-controller fastethernet 0 phy
FastEthernet0
-----------------------------------------------------------
hw_if_index = 2 if_number = 2
PowerPC405 FastEthernet unit 0
PHY Hardware is Broadcom BCM5220 rev. 4 (id_register: 0x40, 0x61E4)
rx_intr: 0 tx_intr: 0 mac_err_isr: 0 phy_link_isr:0
Current station address 00d0.2bfd.d737, default address 00d0.2bfd.d737
MAL register dump:
malcr
0x00004082
malesr
0x00000000
malier
0x00000000
maltxcasr
0x80000000
maltxcarr
0x80000000
maltxeobisr
0x80000000
maltxdeir
0x00000000
malrxcasr
0x80000000
malrxcarr
0x80000000
manuals search engine
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
for descriptions of the Transmit and Receive fields.
Receive
33181 Bytes
437 Multicast frames
0x100
0x101
0x102
0x104
0x105
0x106
0x107
0x110
0x111
78 Unicast frames
0 Broadcast frames
0 Unicast bytes
0 Multicast bytes
0 Broadcast bytes
0 Alignment errors
0 FCS errors
0 Oversize frames
0 Undersize frames
0 Collision fragments
0 Minimum size frames
0 65 to 127 byte frames
0 128 to 255 byte frames
0 256 to 511 byte frames
0 512 to 1023 byte frames
0 1024 to 1518 byte frames
0 Overrun frames
0 Pause frames
0 Symbol error frames
0 Invalid frames, too large
0 Valid frames, too large
0 Invalid frames, too small
0 Valid frames, too small
0 Too old frames
0 Valid oversize frames
0 System FCS error frames
0 RxPortFifoFull drop frame
OL-21522-02
Advertisement
Table of Contents
