Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
ip igmp snooping tcn flood
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
OL-21522-02
Downloaded from
www.Manualslib.com
Use the ip igmp snooping tcn flood interface configuration command on the switch stack or on a
standalone switch to specify multicast flooding as the Internet Group Management Protocol (IGMP)
snooping spanning-tree Topology Change Notification (TCN) behavior. Use the no form of this
command to disable the multicast flooding.
ip igmp snooping tcn flood
no ip igmp snooping tcn flood
This command has no arguments or keywords.
Multicast flooding is enabled on an interface during a spanning-tree TCN event.
Interface configuration
Release
12.2(53)SE2
When the switch receives a TCN, multicast traffic is flooded to all the ports until two general queries are
received. If the switch has many ports with attached hosts that are subscribed to different multicast
groups, the flooding might exceed the capacity of the link and cause packet loss.
You can change the flooding query count by using the ip igmp snooping tcn flood query count count
global configuration command.
This example shows how to disable the multicast flooding on an interface:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# no ip igmp snooping tcn flood
You can verify your settings by entering the show ip igmp snooping privileged EXEC command.
Command
ip igmp snooping
ip igmp snooping tcn
show ip igmp snooping
manuals search engine
Modification
This command was introduced.
Description
Enables IGMP snooping on the switch or on a VLAN.
Configures the IGMP TCN behavior on the switch.
Displays the IGMP snooping configuration of the switch or the VLAN.
Catalyst 3750-X and 3560-X Switch Command Reference
ip igmp snooping tcn flood
2-271