Switchport Nonegotiate - Cisco Catalyst 3560-X Command Reference Manual
Hide thumbs
Also See for Catalyst 3560-X:
- Software configuration manual (1538 pages) ,
- Command reference manual (1244 pages) ,
- Manual (276 pages)
Table of Contents
Advertisement
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
switchport nonegotiate
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
OL-21522-02
Downloaded from
www.Manualslib.com
Use the switchport nonegotiate interface configuration command on the switch stack or on a standalone
switch to specify that Dynamic Trunking Protocol (DTP) negotiation packets are not sent on the Layer 2
interface. The switch does not engage in DTP negotiation on this interface. Use the no form of this
command to return to the default setting.
switchport nonegotiate
no switchport nonegotiate
This command has no arguments or keywords.
The default is to use DTP negotiation to learn the trunking status.
Interface configuration
Release
12.2(53)SE2
The no form of the switchport nonegotiate command removes nonegotiate status.
This command is valid only when the interface switchport mode is access or trunk (configured by using
the switchport mode access or the switchport mode trunk interface configuration command). This
command returns an error if you attempt to execute it in dynamic (auto or desirable) mode.
Internetworking devices that do not support DTP might forward DTP frames improperly and cause
misconfigurations. To avoid this, you should turn off DTP by using the switchport no negotiate
command to configure the interfaces connected to devices that do not support DTP to not forward DTP
frames.
When you enter the switchport nonegotiate command, DTP negotiation packets are not sent on the
interface. The device does or does not trunk according to the mode parameter: access or trunk.
If you do not intend to trunk across those links, use the switchport mode access interface
•
configuration command to disable trunking.
To enable trunking on a device that does not support DTP, use the switchport mode trunk and
•
switchport nonegotiate interface configuration commands to cause the interface to become a trunk
but to not generate DTP frames.
manuals search engine
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
switchport nonegotiate
2-883
Advertisement
Table of Contents
