Cisco Catalyst 3560-X Command Reference Manual page 250

Hide thumbs Also See for Catalyst 3560-X:

Table of Contents

Related Commands

Catalyst 3750-X and 3560-X Switch Command Reference

Downloaded from

www.Manualslib.com

If your switch receives its IP address from a Bootstrap Protocol (BOOTP) or a DHCP server and you

remove the switch IP address by using the no ip address command, IP processing is disabled, and the

BOOTP or the DHCP server cannot reassign the address.

A Layer 3 switch can have an IP address assigned to each routed port and SVI. The number of routed

ports and SVIs that you can configure is not limited by software; however, the interrelationship between

this number and the number of other features being configured might have an impact on CPU utilization

due to hardware limitations. You can use the sdm prefer global configuration command to reallocate

system hardware resources based on templates and feature tables. For more information, see the

This example shows how to configure the IP address for the Layer 2 switch on a subnetted network:

Switch(config)# interface vlan 1

Switch(config-if)# ip address 172.20.128.2 255.255.255.0

This example shows how to configure the IP address for a port on the Layer 3 switch:

Switch(config)# ip multicast-routing

Switch(config)# interface gigabitethernet6/0/1

Switch(config-if)# no switchport

Switch(config-if)# ip address 172.20.128.2 255.255.255.0

You can verify your settings by entering the show running-config privileged EXEC command.

show running-config

manuals search engine

Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

Displays the operating configuration. For syntax information, use this

link to the Cisco IOS Release 12.2 Command Reference listing page:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/prod_comma

nd_reference_list.html

Select the Cisco IOS Commands Master List, Release 12.2 to navigate

to the command.

Catalyst 3750-x