Show Interfaces Protected-Ports; Switchport Mode - Cisco 300 Series Cli Manual
Small business 300 series managed switches
command line interface guide release 1.3
Hide thumbs
Also See for 300 Series:
- Cli manual (1117 pages) ,
- Administration manual (586 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
32
496
32.10 show interfaces protected-ports
Use the show interfaces protected-ports EXEC mode command to display
protected ports configuration.
Syntax
show interfaces protected-ports
Parameters
•
interface-id—Specifies an interface ID. The interface ID can be one of the
following types: Ethernet port or port-channel.
•
detailed—Displays information for non-present ports in addition to present
ports.
Default Configuration
Show all protected interfaces. If detailed is not used, only present ports are
displayed.
Command Mode
EXEC mode
Example
switchxxxxxx#show interfaces protected-ports
Interface
State
--------- -------------
gi1
Protected
gi2
Protected
gi3
Unprotected
gi4
Unprotected
32.11 switchport mode
Use the switchport mode Interface Configuration (Ethernet, port-channel) mode
command to configure the VLAN membership mode (access, trunk, general or
Virtual Local Area Network (VLAN) Commands
[interface-id | detailed
78-21075-01 Command Line Interface Reference Guide
]
Advertisement
Table of Contents
