Cisco Catalyst 2960 Command Reference Manual page 267

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

If you use the no service password-recovery command to control end user access to passwords, we

recommend that you save a copy of the config file in a location away from the switch in case the end user

uses the password recovery procedure and sets the system back to default values. Do not keep a backup

copy of the config file on the switch.

If the switch is operating in VTP transparent mode, we recommend that you also save a copy of the

vlan.dat file in a location away from the switch.

You can verify if password recovery is enabled or disabled by entering the show version privileged

EXEC command.

This example shows how to disable password recovery on a switch so that a user can only reset a

password by agreeing to return to the default configuration.

Switch(config)# no service-password recovery

Switch(config)# exit

Related Commands

show version

Displays version information for the hardware and firmware.

Catalyst 2960 Switch Command Reference

service password-recovery

Show Quick Links

Table of Contents