Cisco Catalyst 2960 Command Reference Manual page 439

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

The sending of SNMP traps is disabled.

Command Modes

Global configuration

Command History

Usage Guidelines

Specify the host (NMS) that receives the traps by using the snmp-server host global configuration

command. If no trap types are specified, all trap types are sent.

When supported, use the snmp-server enable traps command to enable sending of traps or informs.

Informs are not supported in SNMPv1.

To enable more than one type of trap, you must enter a separate snmp-server enable traps command

for each trap type.

This example shows how to send VTP traps to the NMS:

Switch(config)# snmp-server enable traps vtp

You can verify your setting by entering the show vtp status or the show running-config privileged

EXEC command.

Related Commands

show running-config

snmp-server host

Modification

This command was introduced.

Displays the running configuration on the switch. For syntax information,

select Cisco IOS Configuration Fundamentals Command Reference,

Release 12.2 > File Management Commands > Configuration File

Management Commands.

Specifies the host that receives SNMP traps.

snmp-server enable traps

Catalyst 2960 Switch Command Reference

Show Quick Links

Table of Contents