Setup Express - Cisco Catalyst 2960 Command Reference Manual
Hide thumbs
Also See for Catalyst 2960:
- Configuration manual (2288 pages) ,
- Software configuration manual (980 pages) ,
- Command reference manual (800 pages)
Table of Contents
Advertisement
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
setup express
Use the setup express global configuration command to enable Express Setup mode. Use the no form
of this command to disable Express Setup mode.
Syntax Description
This command has no arguments or keywords.
Defaults
Express Setup is enabled.
Command Modes
Global configuration
Command History
Release
12.2(25)FX
Usage Guidelines
When Express Setup is enabled on a new (unconfigured) switch, pressing the Mode button for 2 seconds
activates Express Setup. You can access the switch through an Ethernet port by using the IP address
10.0.0.1 and then can configure the switch with the web-based Express Setup program or the
command-line interface (CLI)-based setup program.
When you press the Mode button for 2 seconds on a configured switch, the LEDs above the Mode button
start blinking. If you press the Mode button for a total of 10 seconds, the switch configuration is deleted,
and the switch reboots. The switch can then be configured like a new switch, either through the
web-based Express Setup program or the CLI-based setup program.
As soon as you make any change to the switch configuration (including entering no at the beginning of
Note
the CLI-based setup program), configuration by Express Setup is no longer available. You can only run
Express Setup again by pressing the Mode button for 10 seconds. This deletes the switch configuration
and reboots the switch.
If Express Setup is active on the switch, entering the write memory or copy running-configuration
startup-configuration privileged EXEC commands deactivates Express Setup. The IP address 10.0.0.1
is no longer valid on the switch, and your connection using this IP address ends.
The primary purpose of the no setup express command is to prevent someone from deleting the switch
configuration by pressing the Mode button for 10 seconds.
78-16882-01
setup express
no setup express
Modification
This command was introduced.
Catalyst 2960 Switch Command Reference
setup express
2-247
Hide quick links:
Advertisement
Table of Contents
