Siemens SIMATIC S7 System Manual page 636

Hide thumbs Also See for SIMATIC S7:

Table of Contents

Open loop motion control

12.6 Subroutines created by the Motion wizard for the Axis of Motion

The Res parameter must be set to the resolution of the absolute encoder connected to your

servo motor. For example, the single turn resolution of a SIMOTICS S-1FL6 servo motor with

absolute encoder is 20 bits or 1048576.

Set the Drive parameter to match the RS485 address of the servo drive to be accessed by

this subroutine. Valid addresses of individual drives are 0 to 31.

Set the Port parameter to designate the CPU port to be used to communicate with the servo

● 0: Onboard RS485 port (Port 0)

● 1: RS485/RS232 signal board (if present, Port 1)

The Done parameter turns on when the subroutine's work is complete.

The Error parameter (Page 659) contains the result of this subroutine.

The D_Pos parameter contains the current absolute position returned by the servo drive.

To use this subroutine, you must configure the measurement system setting for this Axis of

Motion to Engineering Units.

Additional subroutines

The Motion wizard also creates the subroutines ABSPOS_SBR and ABSPOS_INT when you

enable read position in the wizard configuration to read an absolute position from a drive.

System Manual, V2.3, 07/2017, A5E03822230-AF

S7-200 SMART

Show Quick Links

Table of Contents

Troubleshooting

Simatic s7-200 smart