Mitsubishi Electric MELSEC iQ-R Series User Manual page 8
Motion module
Hide thumbs
Also See for MELSEC iQ-R Series:
- Programming manual (2110 pages) ,
- User manual (760 pages) ,
- Reference manual (498 pages)
Table of Contents
Advertisement
[Wiring Precautions]
CAUTION
● When disconnecting the cable from the module, do not pull the cable by the cable part. For the cable
with connector, hold the connector part of the cable. For the cable connected to the terminal block,
loosen the terminal screw. Pulling the cable connected to the module may result in malfunction or
damage to the module or cable.
● Prevent foreign matter such as dust or wire chips from entering the module. Such foreign matter can
cause a fire, failure, or malfunction.
● A protective film is attached to the top of the module to prevent foreign matter, such as wire chips,
from entering the module during wiring. Do not remove the film during wiring. Remove it for heat
dissipation before system operation.
● Programmable controllers must be installed in control panels. Connect the main power supply to the
power supply module in the control panel through a relay terminal block. Wiring and replacement of a
power supply module must be performed by qualified maintenance personnel with knowledge of
protection against electric shock. For wiring, refer to the MELSEC iQ-R Module Configuration Manual.
● For Ethernet cables to be used in the system, select the ones that meet the specifications in the user's
manual for the module used. If not, normal data transmission is not guaranteed.
[Startup and Maintenance Precautions]
WARNING
● Do not touch any terminal while power is on. Doing so will cause electric shock or malfunction.
● Correctly connect the battery connector. Do not charge, disassemble, heat, short-circuit, solder, or
throw the battery into the fire. Also, do not expose it to liquid or strong shock. Doing so will cause the
battery to produce heat, explode, ignite, or leak, resulting in injury and fire.
● Shut off the external power supply (all phases) used in the system before cleaning the module or
retightening the terminal screws, connector screws, or module fixing screws. Failure to do so may
result in electric shock.
6
- Quick Links:
- Introduction
- Axis
- Chapter 1 Axis Setting
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Mitsubishi Electric MELSEC iQ-R Series
Related Products for Mitsubishi Electric MELSEC iQ-R Series
- Mitsubishi Electric MELSEC iQ-R C
- Mitsubishi Electric MELSEC iQ-F
- Mitsubishi Electric MELSEC iQ-R
- Mitsubishi Electric MELSEC-I/OLINK
- Mitsubishi Electric MELSEC iQ-F Series
- Mitsubishi Electric MELSEC iQ-R OPC UA
- Mitsubishi Electric MELSEC iQ-R MELSECWinCPU
- Mitsubishi Electric MELSEC iQ-R CC-Link IE TSN Plus
- Mitsubishi Electric MELSEC iQ-R CC-Link IE TSN
- Mitsubishi Electric MELSECiQ-FX5-40SSC-S
- Mitsubishi Electric MELSECiQ-FX5-80SSC-S
- Mitsubishi Electric MELSEC iQ-R C Series
- Mitsubishi Electric MELSEC FX0N-3A
- Mitsubishi Electric MELSEC-QD75MH2
- Mitsubishi Electric MELSEC-Q06UDVCPU
- Mitsubishi Electric MELSEC-QD77GF16