Mitsubishi Electric MELSEC iQ-R Series User Manual page 4
Motion module
Hide thumbs
Also See for MELSEC iQ-R Series:
- Programming manual (2110 pages) ,
- User manual (760 pages) ,
- Reference manual (498 pages)
Table of Contents
Advertisement
[Design Precautions]
WARNING
● Configure safety circuits external to the programmable controller to ensure that the entire system
operates safely even when a fault occurs in the external power supply or the programmable controller.
Failure to do so may result in an accident due to an incorrect output or malfunction.
(1) Emergency stop circuits, protection circuits, and protective interlock circuits for conflicting
operations (such as forward/reverse rotations or upper/lower limit positioning) must be configured
external to the programmable controller.
(2) When the programmable controller detects an abnormal condition, it stops the operation and all
outputs are:
• Turned off if the overcurrent or overvoltage protection of the power supply module is activated.
• Held or turned off according to the parameter setting if the self-diagnostic function of the CPU
module detects an error such as a watchdog timer error.
(3) All outputs may be turned on if an error occurs in a part, such as an I/O control part, where the
CPU module cannot detect any error. To ensure safety operation in such a case, provide a safety
mechanism or a fail-safe circuit external to the programmable controller. For a fail-safe circuit
example, refer to "General Safety Requirements" in the MELSEC iQ-R Module Configuration
Manual.
(4) Outputs may remain on or off due to a failure of a component such as a relay and transistor in an
output circuit. Configure an external circuit for monitoring output signals that could cause a
serious accident.
● In an output circuit, when a load current exceeding the rated current or an overcurrent caused by a
load short-circuit flows for a long time, it may cause smoke and fire. To prevent this, configure an
external safety circuit, such as a fuse.
● Configure a circuit so that the programmable controller is turned on first and then the external power
supply. If the external power supply is turned on first, an accident may occur due to an incorrect output
or malfunction.
● For the operating status of each station after a communication failure, refer to manuals relevant to the
network. Incorrect output or malfunction due to a communication failure may result in an accident.
2
- Quick Links:
- Introduction
- Axis
- Chapter 1 Axis Setting
Hide quick links:
Advertisement
Table of Contents
Related Manuals for Mitsubishi Electric MELSEC iQ-R Series
Related Products for Mitsubishi Electric MELSEC iQ-R Series
- Mitsubishi Electric MELSEC iQ-R C
- Mitsubishi Electric MELSEC iQ-F
- Mitsubishi Electric MELSEC iQ-R
- Mitsubishi Electric MELSEC-I/OLINK
- Mitsubishi Electric MELSEC iQ-F Series
- Mitsubishi Electric MELSEC iQ-R OPC UA
- Mitsubishi Electric MELSEC iQ-R MELSECWinCPU
- Mitsubishi Electric MELSEC iQ-R CC-Link IE TSN Plus
- Mitsubishi Electric MELSEC iQ-R CC-Link IE TSN
- Mitsubishi Electric MELSECiQ-FX5-40SSC-S
- Mitsubishi Electric MELSECiQ-FX5-80SSC-S
- Mitsubishi Electric MELSEC iQ-R C Series
- Mitsubishi Electric MELSEC FX0N-3A
- Mitsubishi Electric MELSEC-QD75MH2
- Mitsubishi Electric MELSEC-Q06UDVCPU
- Mitsubishi Electric MELSEC-QD77GF16