Cisco ME 3400 Command Reference Manual page 106

Ethernet access switch

Hide thumbs Also See for ME 3400:

Table of Contents

dot1x port-control

To globally disable IEEE 802.1x on the switch, use the no dot1x system-auth-control global

configuration command. To disable IEEE 802.1x on a specific port, use the no dot1x port-control

interface configuration command.

This example shows how to enable IEEE 802.1x on a port:

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# dot1x port-control auto

You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC

Related Commands

Cisco ME 3400 Ethernet Access Switch Command Reference

Switched Port Analyzer (SPAN) and Remote SPAN (RSPAN) destination ports—You can enable

IEEE 802.1x on a port that is a SPAN or RSPAN destination port. However, IEEE 802.1x is disabled

until the port is removed as a SPAN or RSPAN destination. You can enable IEEE 802.1x on a SPAN

or RSPAN source port.

[interface interface-id]

Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands

Displays IEEE 802.1x status for the specified port.

Show Quick Links

Table of Contents