Cisco ME 3400 Command Reference Manual page 630
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
storm-control
When the storm control threshold for multicast traffic is reached, all multicast traffic except control
Note
traffic, such as bridge protocol data unit (BDPU) and Cisco Discovery Protocol (CDP) frames, are
blocked. However, the switch does not differentiate between routing updates, such as Open Shortest Path
First (OSPF) and regular multicast data traffic, so both types of traffic are blocked.
The trap and shutdown options are independent of each other.
If you configure the action to be taken as shutdown (the port is error-disabled during a storm) when a
packet storm is detected, you must use the no shutdown interface configuration command to bring the
interface out of this state. If you do not specify the shutdown action, specify the action as trap (the
switch generates a trap when a storm is detected).
When a storm occurs and the action is to filter traffic, if the falling suppression level is not specified, the
switch blocks all traffic until the traffic rate drops below the rising suppression level. If the falling
suppression level is specified, the switch blocks traffic until the traffic rate drops below this level.
When a broadcast storm occurs and the action is to filter traffic, the switch blocks only broadcast traffic.
For more information, see the software configuration guide for this release.
Examples
This example shows how to enable broadcast storm control with a 75.5-percent rising suppression level:
Switch(config-if)# storm-control broadcast level 75.5
This example shows how to enable unicast storm control on a port with a 87-percent rising suppression
level and a 65-percent falling suppression level:
Switch(config-if)# storm-control unicast level 87 65
This example shows how to enable multicast storm control on a port with a 2000-packets-per-second
rising suppression level and a 1000-packets-per-second falling suppression level:
Switch(config-if)# storm-control multicast level pps 2k 1k
This example shows how to enable the shutdown action on a port:
Switch(config-if)# storm-control action shutdown
You can verify your settings by entering the show storm-control privileged EXEC command.
Related Commands
Command
show storm-control
Cisco ME 3400 Ethernet Access Switch Command Reference
2-604
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Displays broadcast, multicast, or unicast storm control settings on all
interfaces or on a specified interface.
OL-9640-07
Hide quick links:
Advertisement
Table of Contents
