Cisco ME 3400 Command Reference Manual page 221
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Chapter 2
Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Enter the drop-threshold keyword to control the number of protocol packets per second that are received
on an interface before it drops packets. When no protocol option is specified with a keyword, the
threshold is applied to each of the tunneled Layer 2 protocol types. If you also set a shutdown threshold
on the interface, the drop-threshold value must be less than or equal to the shutdown-threshold value.
When the drop threshold is reached, the interface drops Layer 2 protocol packets until the rate at which
they are received is below the drop threshold.
The configuration is saved in NVRAM.
For more information about Layer 2 protocol tunneling, see the software configuration guide for this
Note
release.
Examples
This example shows how to enable protocol tunneling for CDP packets and to configure the shutdown
threshold as 50 packets per second:
Switch(config-if)# l2protocol-tunnel cdp
Switch(config-if)# l2protocol-tunnel shutdown-threshold cdp 50
This example shows how to enable protocol tunneling for STP packets and to configure the drop
threshold as 400 packets per second:
Switch(config-if)# l2protocol-tunnel stp
Switch(config-if)# l2protocol-tunnel drop-threshold stp 400
This example shows how to enable point-to-point protocol tunneling for PAgP and UDLD packets and
to configure the PAgP drop threshold as 1000 packets per second:
Switch(config-if)# l2protocol-tunnel point-to-point pagp
Switch(config-if)# l2protocol-tunnel point-to-point udld
Switch(config-if)# l2protocol-tunnel drop-threshold point-to-point pagp 1000
Related Commands
Command
l2protocol-tunnel cos
show errdisable recovery
show l2protocol-tunnel
OL-9640-07
Description
Configures a class of service (CoS) value for all tunneled Layer 2
protocol packets.
Displays errdisable recovery timer information.
Displays information about ports configured for Layer 2 protocol
tunneling, including port, protocol, CoS, and threshold.
Cisco ME 3400 Ethernet Access Switch Command Reference
l2protocol-tunnel
2-195
Hide quick links:
Advertisement
Table of Contents
