Cisco ME 3400 Command Reference Manual page 436
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
show interfaces rep
Examples
This is sample output from the show interface rep command:
Switch # show interface rep
Interface
---------------------- ------ ------------ ----------- ----
GigabitEthernet 0/1
GigabitEthernet 0/2
FastEthernet 0/4
This is sample output from the show interface rep command when the edge port is configured to have
no REP neighbor. Note the asterisk (*) next to Primary Edge.
Switch# show interface rep
Interface
---------------------- ------ --------------
GigabitEthernet0/1
GigabitEthernet0/2
This is sample output from the show interface rep command when external neighbors are not
configured:
Switch # show interface rep
Interface
---------------------- ------ ------------ ----------- ----
GigabitEthernet0/1
GigabitEthernet0/2
This is sample output from the show interface rep detail command for a specified interface:
Switch # show interface gigabitethernet0/2 rep detail
GigabitEthernet0/2
Segment-id: 1 (Segment)
PortID: 00030019E85BDD00
Preferred flag: No
Operational Link Status: INIT_DOWN
Current Key: 00000000000000000000
Port Role: Fail
Blocked VLAN: 1-4094
Admin-vlan: 1
Preempt Delay Timer: disabled
LSL Ageout Timer: 5000 ms
Configured Load-balancing Block Port: 1234567890123456
Configured Load-balancing Block VLAN: 1-4094
STCN Propagate to: none
LSL PDU rx: 0, tx: 0
HFL PDU rx: 0, tx: 0
BPA TLV rx: 0, tx: 0
BPA (STCN, LSL) TLV rx: 0, tx: 0
BPA (STCN, HFL) TLV rx: 0, tx: 0
EPA-ELECTION TLV rx: 0, tx: 0
EPA-COMMAND TLV rx: 0, tx: 0
EPA-INFO TLV rx: 0, tx: 0
Related Commands
Command
rep segment
show rep topology
[detail]
Cisco ME 3400 Ethernet Access Switch Command Reference
2-410
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Seg-id
Type
1
Primary Edge
1
Edge
2
Seg-id Type
2
2
Primary Edge*
Seg-id
Type
1
2
REP enabled
Description
Enables REP on an interface and assigns a segment ID. This command is also
used to configure a port as an edge port, a primary edge port, or a preferred
port.
Displays information about all ports in the segment, including which one was
configured and selected as the primary edge port.
LinkOp
Role
TWO_WAY
Open
TWO_WAY
Open
INIT_DOWN
Fail
LinkOp
Role
----------- ----
TWO_WAY
Open
TWO_WAY
Open
LinkOp
Role
NO_NEIGHBOR FailNoNbr
NO_NEIGHBOR FailLogOpen
OL-9640-07
Hide quick links:
Advertisement
Table of Contents
