Snmp Mib Rep Trap-Rate - Cisco ME 3400 Command Reference Manual
Ethernet access switch
Hide thumbs
Also See for ME 3400:
- Software configuration manual (1138 pages) ,
- Command reference manual (950 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
snmp mib rep trap-rate
Use the snmp mib rep trap-rate global configuration command to configure the sending of Resilient
Ethernet Protocol (REP) SNMP traps when there is a link operational status or port role change. Use the
no version of the command to disable sending of the REP trap.
Syntax Description
trap-rate value
Defaults
Sending REP traps is disabled.
Command Modes
Global configuration
Command History
Release
12.2(40)SE
Usage Guidelines
Use this command to enable the switch to send REP specific traps corresponding to link operational
status changes and port role changes.
Examples
This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10
Related Commands
Command
show running config
OL-9640-07
snmp mib rep trap-rate value
no snmp mib rep trap-rate
Set the number of REP traps sent per second. The range is from 0 to 1000. The
default is 0 (no limit imposed; a trap is sent at every occurrence).
Modification
This command was introduced.
Description
Verifies that REP traps are configured.
Cisco ME 3400 Ethernet Access Switch Command Reference
snmp mib rep trap-rate
2-541
Hide quick links:
Advertisement
Table of Contents
