Span Session Source Interface - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

span session source interface

To configure the SPAN traffic in both ingress (rx) and egress (tx) directions, use the span session source

interface command in Configuration mode.

Syntax Description

interface type

Command Modes

Configuration mode

Command History

Usage Guidelines

The following example shows how to configure the SPAN traffic in both ingress and egress directions.

switch#config

Enter configuration commands, one per line. End with CNTL/Z.

switch(config)# span session 1

switch(config-span)# source interface fc 1/5 rx

switch(config-span)# source interface fc 1/5 tx

switch(config-span)# destination interface fc 1/5

Related Commands

show span session

OL-18089-01, Cisco MDS NX-OS Release 4.x

span session session-id source interface interface type

Specifies the SPAN session ID.

Specifies the destination interface mapped to a Fiber Channel or FC tunnel.

Modification

This command was introduced.

Enabled SPAN traffic in both ingress (rx) and egress (tx) directions for

Generation 2 Fabric Switches.

Displays specific information about a Switched Port Analyzer (SPAN)

span session source interface

Cisco MDS 9000 Family Command Reference