Peer-Info Ipaddr - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

peer-info ipaddr

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

peer-info ipaddr

To configure the peer information for the FCIP interface, use the peer-info ipaddr command. To remove

the peer information for the FCIP interface, use the no form of the command.

Syntax Description

ipaddr address

Command Modes

Interface configuration submode.

Command History

Usage Guidelines

Access this command from the

The basic FCIP configuration uses the peer's IP address to configure the peer information. You can also

use the peer's port number, port profile ID, or port WWN to configure the peer information. If you do

not specify a port, the default 3225 port number is used to establish connection.

The following command assigns an IP address to configure the peer information. Since no port is

specified, the default port number, 3225, is used.

switch# config terminal

switch(config)# interface fcip 10

switch(config-if)# peer-info ipaddr 209.165.200.226

The following command deletes the assigned peer port information.

switch(config-if)# no peer-info ipaddr 209.165.200.226

The following command assigns the IP address and sets the peer TCP port to 3000. The valid port

number range is from 0 to 65535.

switch(config-if)# peer-info ipaddr 209.165.200.226 port 3000

The following command deletes the assigned peer port information.

switch(config-if)# no peer-info ipaddr 209.165.200.226 port 2000

Cisco MDS 9000 Family Command Reference

peer-info ipaddr address [port number]

no peer-info ipaddr address [port number]

Configures the peer IP address.

Configures a peer port. The range is 1 to 65535.

Modification

This command was introduced.

switch(config-if)#

OL-18089-01, Cisco MDS NX-OS Release 4.x