Shutdown (Interface Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Cisco mds 9000 family command reference guide - release 4.x (ol-18089-01, february 2009)

Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:

Table of Contents

shutdown (interface configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

shutdown (interface configuration submode)

To disable an Cisco SME interface, use the shutdown command. To enable the interface, use the no form

of the command.

Syntax Description

This command has no arguments or keywords.

Command Modes

Interface configuration submode.

Command History

Usage Guidelines

The default state for Cisco SME interfaces is shutdown. Use the no shutdown command to enable the

interface to carry traffic.

The show interface command shows that the Cisco SME interface is down until the interface is added

to a cluster.

The following example enables a Cisco SME interface:

switch# config t

switch(config)# interface sme 4/1

switch(config-if)# no shutdown

The following example disables a Cisco SME interface:

switch# config t

switch(config)# interface sme 4/1

switch(config-if)# shutdown

Related Commands

show interface sme

Cisco MDS 9000 Family Command Reference

Modification

This command was introduced.

Displays information about the Cisco SME interface.

OL-18089-01, Cisco MDS NX-OS Release 4.x