Chapter 43
Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Assigning WWNs to iSLB Initiators
An iSLB host is mapped to an N port's WWNs by one of the following mechanisms:
•
•
Assigning WWNs for iSLB initiators is the same as for iSCSI initiators. For information on dynamic and
Note
static mapping, see the
We recommend using the SystemAssign system-assign option. If you manually assign a WWN, you
Tip
must ensure its uniqueness (see the
previously assigned WWNs.
Making the Dynamic iSLB Initiator WWN Mapping Static
After a dynamic iSLB initiator has logged in, you may decide to permanently keep the automatically
assigned nWWN/pWWN mapping to allow this initiator to use the same mapping the next time it logs
in .
You can convert a dynamic iSLB initiator to a static iSLB initiator and make its WWNs persistent (see
"Dynamic Mapping" section on page
You cannot convert a dynamic iSCSI initiator to a static iSLB initiator or a dynamic iSLB initiator to a
Note
static iSCSI initiator.
Making the dynamic mapping for iSLB initiators static is the same as for iSCSI. See the
Note
Dynamic iSCSI Initiator WWN Mapping Static" section on page
Only statically mapped iSLB initiator configuration is distributed throughout the fabric using CFS.
Note
Dynamically and statically configured iSCSI initiator configurations are not distributed.
To permanently keep the automatically assigned nWWN/pWWN mapping, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
OL-18084-01, Cisco MDS NX-OS Release 4.x
Dynamic mapping (default)
Static mapping
"WWN Assignment for iSCSI Initiators" section on page
"World Wide Names" section on page
43-12).
Purpose
Enters configuration mode.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring iSLB
43-12.
30-9). You should not use any
"Making the
43-14.
43-43