Enabling Ivr - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual
Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs
Also See for AP776A - Nexus Converged Network Switch 5020:
- Command reference manual (1640 pages) ,
- Configuration manual (1486 pages) ,
- Reference (886 pages)
Table of Contents
Advertisement
Chapter 23
Configuring Inter-VSAN Routing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Enabling IVR
The IVR feature must be enabled in all border switches in the fabric that participate in the IVR. By
default, this feature is disabled in all switches in the Cisco MDS 9000 Family. You can manually enable
IVR on all required switches in the fabric or configure fabric-wide distribution of the IVR configuration
("Distributing the IVR Configuration using CFS" section on page
The configuration and verification commands for the IVR feature are only available when IVR is enabled
Note
on a switch. When you disable this configuration, all related configurations are automatically discarded.
To enable IVR on any participating switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# feature ivr
switch(config)# no feature ivr
OL-18084-01, Cisco MDS NX-OS Release 4.x
Copying the Active IVR Service Group Database, page 23-15
Clearing IVR Service Group Database, page 23-15
Verifying IVR Service Group Configuration, page 23-15
About AFIDs, page 23-16
Configuring Default AFIDs, page 23-16
Configuring Individual AFIDs, page 23-17
Verifying the AFID Database Configuration, page 23-17
About IVR Without IVR NAT or Auto Topology, page 23-23
Activating a Manually Configured IVR Topology, page 23-20
Adding an IVR-Enabled Switch to an Existing IVR Topology, page 23-21
Copying the Active IVR Topology, page 23-22
Clearing the Configured IVR Topology Database, page 23-22
Migrating from IVR Auto Topology Mode to Manual Mode, page 23-23
About IVR Virtual Domains, page 23-23
Configuring IVR Virtual Domains, page 23-24
Verifying the IVR Virtual Domain Configuration, page 23-24
Clearing the IVR fcdomain Database, page 23-24
About Persistent FC IDs for IVR, page 23-25
Configuring Persistent FC IDs for IVR, page 23-26
Verifying the Persistent FC ID Configuration, page 23-26
Configuring IVR Logging Levels, page 23-27
Verifying Logging Level Configuration, page 23-27
23-10).
Purpose
Enters configuration mode.
Enables IVR on the switch.
Disables (default) IVR on the switch.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring IVR
23-9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
