Cisco 7604 Configuration Manual page 693
Catalyst 6500 series switch and cisco 7600 series router firewall services module configuration guide using the cli
Hide thumbs
Also See for 7604:
- Configuration manual (1011 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Appendix E
Addresses, Protocols, and Ports
Global Address
The general format of an IPv6 global unicast address is a global routing prefix followed by a subnet ID
followed by an interface ID. The global routing prefix can be any prefix not reserved by another IPv6
address type (see
prefixes).
All global unicast addresses, other than those that start with binary 000, have a 64-bit interface ID in the
Modified EUI-64 format. See
EUI-64 format for interface identifiers.
Global unicast address that start with the binary 000 do not have any constraints on the size or structure
of the interface ID portion of the address. One example of this type of address is an IPv6 address with
an embedded IPv4 address (see
Site-Local Address
Site-local addresses are used for addressing within a site. They can be use to address an entire site
without using a globally unique prefix. Site-local addresses have the prefix FEC0::/10, followed by a
54-bit subnet ID, and end with a 64-bit interface ID in the modified EUI-64 format.
Site-local Routers do not forward any packets that have a site-local address for a source or destination
outside of the site. Therefore, site-local addresses can be considered private addresses.
Link-Local Address
All interfaces are required to have at least one link-local address. You can configure multiple IPv6
addresses per interfaces, but only one link-local address.
A link-local address is an IPv6 unicast address that can be automatically configured on any interface
using the link-local prefix FE80::/10 and the interface identifier in modified EUI-64 format. Link-local
addresses are used in the neighbor discovery protocol and the stateless autoconfiguration process. Nodes
with a link-local address can communicate; they do not need a site-local or globally unique address to
communicate.
Routers do not forward any packets that have a link-local address for a source or destination. Therefore,
link-local addresses can be considered private addresses.
IPv4-Compatible IPv6 Addresses
There are two types of IPv6 addresses that can contain IPv4 addresses.
The first type is the "IPv4-compatibly IPv6 address." The IPv6 transition mechanisms include a
technique for hosts and routers to dynamically tunnel IPv6 packets over IPv4 routing infrastructure. IPv6
nodes that use this technique are assigned special IPv6 unicast addresses that carry a global IPv4 address
in the low-order 32 bits. This type of address is termed an "IPv4-compatible IPv6 address" and has the
format ::y.y.y.y, where y.y.y.y is an IPv4 unicast address.
Note
The IPv4 address used in the "IPv4-compatible IPv6 address" must be a globally-unique IPv4 unicast
address.
The second type of IPv6 address which holds an embedded IPv4 address is called the "IPv4-mapped
IPv6 address." This address type is used to represent the addresses of IPv4 nodes as IPv6 addresses. This
type of address has the format ::FFFF:y.y.y.y, where y.y.y.y is an IPv4 unicast address.
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
IPv6 Address Prefixes, page
Interface Identifiers, page
IPv4-Compatible IPv6 Addresses, page
E-10, for information about the IPv6 address type
E-8, for more information about the Modified
E-7).
IPv6 Addresses
E-7
- Quick Links:
- C H a P T E...
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
