Table of Contents
Advertisement
Chapter
CESM 8-Port LED Indicators
The CESM 8-port LED indicators are described in Table 4-5. All LEDs are located on the faceplate of
the front card.
Table 4-5
Type of LED
ACT
STBY
FAIL
PORT
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
CESM 8-Port LED Indicators
Color
Meaning
Green
On indicates the card set is in active mode.
Yellow
•
Slow blink without the Active LED indicates the card is in the
boot state.
Fast blink with the Standby LED indicates the card is being
•
downloaded.
Fast blink indicates the service module is passing BRAM
•
channel information to the ASC.
Steady yellow indicates the card is in Standby mode and the
•
firmware is executing ADMIN code.
Red
•
Steady Red with Active and Standby LEDs off indicates either
the card is in the Reset condition, the card has failed, or the card
set is not complete (no line module).
•
Steady Red with Active LED on indicates the card was active
prior to failing
•
Steady Red with Standby LED on indicates the card was
standby prior to failing.
Both standby and red LED alight indicates self-test failure.
•
Green
Green indicates the port is active.
Red
•
Red indicates there is local alarm on the port.
Off indicates the port has not been activated (upped).
•
Circuit Emulation Service Modules
Cisco MGX 8220 Installation and Configuration
4-31
Advertisement
Table of Contents
Troubleshooting
