Configuring A Trunk Port - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Configuring VLAN Trunks
•
•
Configuring a Trunk Port
Beginning in privileged EXEC mode, follow these steps to configure a port as 802.1Q trunk port:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
switchport mode {dynamic {auto |
desirable} | trunk}
Step 4
switchport access vlan vlan-id
Step 5
switchport trunk native vlan vlan-id
Step 6
end
Step 7
show interfaces interface-id switchport Display the switchport configuration of the interface in the Administrative
Step 8
show interfaces interface-id trunk
Step 9
copy running-config startup-config
To return an interface to its default configuration, use the default interface interface-id interface
configuration command. To reset all trunking characteristics of a trunking interface to the defaults, use
the no switchport trunk interface configuration command. To disable trunking, use the switchport
mode access interface configuration commands to configure the port as a static-access port.
Catalyst 2950 Desktop Switch Software Configuration Guide
13-22
If you try to enable 802.1X on a trunk port, an error message appears, and 802.1X is not enabled. If
you try to change the mode of an 802.1X-enabled port to trunk, the port mode is not changed.
A port in dynamic mode can negotiate with its neighbor to become a trunk port. If you try to enable
802.1X on a dynamic port, an error message appears, and 802.1X is not enabled. If you try to change
the mode of an 802.1X-enabled port to dynamic, the port mode is not changed.
Purpose
Enter global configuration mode.
Enter the interface configuration mode and the port to be configured for
trunking.
Configure the interface as a Layer 2 trunk (required only if the interface
is a Layer 2 access port or to specify the trunking mode).
(Optional) Specify the default VLAN, which is used if the interface stops
trunking.
Specify the native VLAN.
Return to privileged EXEC mode.
Mode and the Administrative Trunking Encapsulation fields of the
display.
Display the trunk configuration of the interface.
(Optional) Save your entries in the configuration file.
•
dynamic auto—Set the interface to a trunk link if the neighboring
interface is set to trunk or desirable mode.
dynamic desirable—Set the interface to a trunk link if the
•
neighboring interface is set to trunk, desirable, or auto mode.
trunk—Set the interface in permanent trunking mode and negotiate
•
to convert the link to a trunk link even if the neighboring interface is
not a trunk interface.
Chapter 13
Configuring VLANs
78-11380-04
Advertisement
Table of Contents
Troubleshooting
