Configuring Snmp; Default Snmp Configuration - Cisco Catalyst 2950 Software Configuration Manual

Hide thumbs Also See for Catalyst 2950:

Table of Contents

Configuring SNMP

Figure 22-1 SNMP Network

SNMP Manager

For information on supported MIBs and how to access them, refer to

Configuring SNMP

This section describes how to configure SNMP on your switch. It contains this configuration

information:

Table 22-2 Default SNMP Configuration

SNMP community strings

SNMP trap receiver

Catalyst 2950 Desktop Switch Software Configuration Guide

Get-request, Get-next-request,

Get-bulk, Set-request

Get-response, traps

Default SNMP Configuration, page 22-4

Configuring Community Strings, page 22-5

Configuring Trap Managers and Enabling Traps, page 22-7

Setting the Agent Contact and Location Information, page 22-9

Limiting TFTP Servers Used Through SNMP, page 22-9

SNMP Examples, page 22-10

shows the default SNMP configuration.

Network device

Appendix A, "Supported MIBs."

Default Setting

Read-Only: Public

Read-Write: Private

Read-Write-all: Secret

None configured

None enabled

Configuring SNMP