Configuring The Port Priority - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Configuring Spanning-Tree Features
Beginning in privileged EXEC mode, follow these steps to configure a switch as the secondary root
switch:
Command
Step 1
configure terminal
Step 2
spanning-tree vlan vlan-id root secondary
[diameter net-diameter [hello-time
seconds]]
Step 3
end
Step 4
show spanning-tree detail
Step 5
copy running-config startup-config
To return the switch to its default setting, use the no spanning-tree vlan vlan-id root global
configuration command.
Configuring the Port Priority
If a loop occurs, spanning tree uses the port priority when selecting an interface to put into the
forwarding state. You can assign higher priority values (lower numerical values) to interfaces that you
want selected first and lower priority values (higher numerical values) that you want selected last. If all
interfaces have the same priority value, spanning tree puts the interface with the lowest interface number
in the forwarding state and blocks the other interfaces.
Cisco IOS uses the port priority value when the interface is configured as an access port and uses VLAN
port priority values when the interface is configured as a trunk port.
Beginning in privileged EXEC mode, follow these steps to configure the port priority of an interface:
Command
Step 1
configure terminal
Step 2
interface interface-id
Catalyst 2950 Desktop Switch Software Configuration Guide
10-14
Purpose
Enter global configuration mode.
Configure a switch as the secondary root switch.
•
For vlan-id, the range is 1 to 4094 when the enhanced software
image is installed and 1 to 1005 when the standard software
image is installed. Do not enter leading zeros.
•
(Optional) For diameter net-diameter, specify the maximum
number of switches between any two end stations. The range is
2 to 7.
(Optional) For hello-time seconds, specify the interval in
•
seconds between the generation of configuration messages by
the root switch. The range is 1 to 10 seconds; the default is 2
seconds.
Use the same network diameter and hello-time values that you used
when configuring the primary root switch. See the
Root Switch" section on page
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify an
interface to configure.
Valid interfaces include physical interfaces and
port-channel logical interfaces (port-channel
port-channel-number).
Chapter 10
Configuring STP
"Configuring the
10-12.
78-11380-04
Advertisement
Table of Contents
Troubleshooting
