Default Vmps Configuration; Vmps Configuration Guidelines - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Chapter 13
Configuring VLANs
vmps-port-policies vlan-name Purple
device 198.4.254.22 port 0/2
port-group "Executive Row"
Default VMPS Configuration
Table 13-7
Table 13-7 Default VMPS Client and Dynamic Port Configuration
Feature
VMPS domain server
VMPS reconfirm interval
VMPS server retry count
Dynamic ports
VMPS Configuration Guidelines
These guidelines and restrictions apply to dynamic port VLAN membership:
•
•
•
•
•
•
•
•
•
•
•
•
78-11380-04
shows the default VMPS and dynamic port configuration on client switches.
You must configure the VMPS before you configure ports as dynamic.
The communication between a cluster of switches and VMPS is managed by the command switch
and includes port-naming conventions that are different from standard port names. For the
cluster-based port-naming conventions, see the
page
13-31.
When you configure a port as dynamic, the spanning-tree Port Fast feature is automatically enabled
for that port. The Port Fast mode accelerates the process of bringing the port into the forwarding
state. You can disable Port Fast mode on a dynamic port.
802.1X ports cannot be configured as dynamic ports. If you try to enable 802.1X on a
dynamic-access (VQP) port, an error message appears, and 802.1X is not enabled. If you try to
change an 802.1X-enabled port to dynamic VLAN assignment, an error message appears, and the
VLAN configuration is not changed.
Trunk ports cannot be dynamic ports, but you can enter the switchport access vlan dynamic
interface configuration command for a trunk port. In this case, the switch retains the setting and
applies it if the port is later configured as an access port.
You must turn off trunking on the port before the dynamic access setting takes effect.
Dynamic ports cannot be network ports or monitor ports.
Secure ports cannot be dynamic ports. You must disable port security on a port before it becomes
dynamic.
Dynamic ports cannot be members of an EtherChannel group.
Port channels cannot be configured as dynamic ports.
The VTP management domain of the VMPS client and the VMPS server must be the same.
VQP does not support extended-range VLANs (VLAN IDs higher than 1006). Extended-range
VLANs cannot be configured by VMPS.
The VLAN configured on the VMPS server should not be a voice VLAN.
Default Setting
None
60 minutes
3
None configured
"VMPS Database Configuration File" section on
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring VMPS
13-33
Advertisement
Table of Contents
Troubleshooting
