Verifying Your Changes; Change Notification; Error Checking; Saving Your Changes - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Chapter 3
Getting Started with CMS
Verifying Your Changes
CMS provides notification cues to help you track and confirm the changes you make.
Change Notification
A green border around a field or table cell means that you made an unsaved change to the field or table
cell. Previous information in that field or table cell is displayed in the window status bar. When you save
the changes or if you cancel the change, the green border disappears.
Error Checking
A red border around a field means that you entered invalid data in the field. An error message also
displays in the window status bar. When you enter valid data in the field, a green border replaces the red
border until you either save or cancel the change.
If there is an error in communicating with the switch or if you make an error while performing an action,
a popup dialog notifies you about the error.
Saving Your Changes
Note
The Save Configuration option is not available if your switch access level is read-only. For more
information about the read-only access mode, see the
As you make cluster configuration changes (except for changes to the Topology view and in the
Tip
Preferences window), make sure that you periodically save the configuration from the command switch.
The configuration is saved on the command and member switches.
The front-panel images and CMS windows always display the running configuration of the switch.
When you make a configuration change to a switch or switch cluster, the change becomes part of the
running configuration. The change does not automatically become part of the config.txt file in Flash
memory, which is the startup configuration used each time the switch restarts. If you do not save your
changes to Flash memory, they are lost when the switch restarts.
To save all configuration changes to Flash memory, you must select Administration > Save
Configuration.
Catalyst 1900 and Catalyst 2820 switches automatically save configuration changes to Flash memory as
Note
they occur.
78-11380-04
"Access Modes in CMS" section on page
Catalyst 2950 Desktop Switch Software Configuration Guide
Verifying Your Changes
3-30.
3-31
Advertisement
Table of Contents
Troubleshooting
