Qos Configuration For The Intelligent Wiring Closet - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Chapter 24
Configuring QoS
For the Catalyst 2900 and 3500 XL switches, CoS configures each transmit port (the egress port) with a
normal-priority transmit queue and a high-priority transmit queue, depending on the frame tag or the port
information. Frames in the normal-priority queue are forwarded only after frames in the high-priority
queue are forwarded. Frames that have 802.1P CoS values of 0 to 3 are placed in the normal-priority
transmit queue while frames with CoS values of 4 to 7 are placed in the expedite (high-priority) queue.
QoS Configuration for the Intelligent Wiring Closet
The intelligent wiring closet in
is connected to a video server, which has an IP address of 172.20.10.16.
The object of this example is to prioritize the video traffic over all other traffic. To do so, a DSCP of 46
is assigned to the video traffic. This traffic is stored in queue 4, which is serviced more frequently than
the other queues.
Beginning in privileged EXEC mode, follow these steps to configure the switch to prioritize video
packets over all other traffic:
Command
Step 1
configure terminal
Step 2
access-list 1 permit 172.20.10.16
Step 3
class-map videoclass
Step 4
match access-group 1
Step 5
exit
Step 6
policy-map videopolicy
Step 7
class videoclass
Step 8
set ip dscp 46
Step 9
police 5000000 8192 exceed-action drop
Step 10
exit
Step 11
exit
Step 12
interface gigabitethernet0/1
Step 13
service-policy input videopolicy
Step 14
exit
Step 15
interface gigabitethernet0/2
Step 16
wrr-queue bandwidth 1 2 3 4
Step 17
wrr-queue cos-map 4 6 7
78-11380-04
Figure 24-4
is composed of Catalyst 2950 switches. One of the switches
Purpose
Enter global configuration mode.
Define an IP standard ACL, and permit traffic from the video
server at 172.20.10.16.
Create a class map called videoclass, and enter class-map
configuration mode.
Define the match criterion by matching the traffic specified by
ACL 1.
Return to global configuration mode.
Create a policy map called videopolicy, and enter policy-map
configuration mode.
Specify the class on which to act, and enter policy-map class
configuration mode.
For traffic matching ACL 1, set the DSCP of incoming packets to
46.
Define a policer for the classified video traffic to drop traffic that
exceeds 5-Mbps average traffic rate with a 8-K burst size.
Return to policy-map configuration mode.
Return to global configuration mode.
Enter interface configuration mode, and specify the ingress
interface.
Apply the policy to the ingress interface.
Return to global configuration mode.
Enter interface configuration mode, and specify the egress
interface (to configure the queues).
Assign a higher WRR weight to queue 4.
Configure the CoS-to-egress-queue map so that CoS values 6
and 7 select queue 4.
Catalyst 2950 Desktop Switch Software Configuration Guide
QoS Configuration Examples
24-27
Advertisement
Table of Contents
Troubleshooting
