Cisco Catalyst 2950 Software Configuration Manual page 482
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Configuring QoS
Command
Step 5
set {ip dscp new-dscp}
Step 6
police rate-bps burst-byte [exceed-action
{drop | dscp dscp-value}]
Step 7
exit
Step 8
exit
Step 9
interface interface-id
Step 10
service-policy {input policy-map-name}
Step 11
end
Step 12
show policy-map [policy-map-name class
class-name]
Step 13
copy running-config startup-config
To delete an existing policy map, use the no policy-map policy-map-name global configuration
command. To delete an existing class map, use the no class class-map-name policy-map configuration
command. To remove an assigned DSCP value, use the no set {ip dscp new-dscp} policy-map
configuration command. To remove an existing policer, use the no police rate-bps burst-byte
[exceed-action {drop | dscp dscp-value}] policy-map configuration command. To remove the policy
map and interface association, use the no service-policy {input policy-map-name} interface
configuration command.
This example shows how to create a policy map and attach it to an ingress interface. In the configuration,
the IP standard ACL permits traffic from network 10.1.0.0. For traffic matching this classification, the
DSCP value in the incoming packet is trusted. If the matched traffic exceeds an average traffic rate
of 48000 bps and a normal burst size of 8000 bytes, its DSCP is marked down to a value of 10 and
transmitted.
Catalyst 2950 Desktop Switch Software Configuration Guide
24-20
Purpose
Classify IP traffic by setting a new value in the packet.
For ip dscp new-dscp, enter a new DSCP value to be assigned to the
classified traffic. The supported DSCP values are 0, 8, 10, 16, 18, 24,
26, 32, 34, 40, 46, 48, and 56.
Define a policer for the classified traffic.
You can configure up to 60 policers on ingress Gigabit-capable
Ethernet ports and up to 6 policers on ingress 10/100 Ethernet ports.
For rate-bps, specify average traffic rate in bits per second (bps). The
range is 1 Mbps to 100 Mbps for 10/100 Ethernet ports and 8 Mbps to
1000 Mbps for the Gigabit-capable Ethernet ports.
For burst-byte, specify the normal burst size in bytes. The values
supported on the 10/100 ports are 4096, 8192, 16384, 32768, and
65536. The values supported on the Gigabit-capable Ethernet ports are
4096, 8192, 16348, 32768, 65536, 131072, 262144, and 524288.
(Optional) Specify the action to take when the rates are exceeded . Use
the exceed-action drop keywords to drop the packet. Use the
exceed-action dscp dscp-value keywords to mark down the DSCP
value and transmit the packet.
Return to policy-map configuration mode.
Return to global configuration mode.
Enter interface configuration mode, and specify the interface to attach
to the policy map.
Valid interfaces include physical interfaces.
Apply a policy map to the input of a particular interface.
Only one policy map per interface per direction is supported.
Use input policy-map-name to apply the specified policy map to the
input of an interface.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 24
Configuring QoS
78-11380-04
Advertisement
Table of Contents
Troubleshooting
