Device Popup Menus - Cisco Catalyst 2950 Software Configuration Manual
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Command reference manual (686 pages) ,
- Software configuration manual (674 pages)
Table of Contents
Advertisement
Chapter 3
Getting Started with CMS
Device Popup Menus
Specific devices in the Topology view display a specific popup menu:
•
•
•
•
•
•
The Device Manager option in these popup menus is available in read-only mode on Catalyst 2900 XL
Note
and Catalyst 3500 XL switches running Release 12.0(5)WC2 and later. It is also available on
Catalyst 2950 switches running Release 12.1(6)EA2 and later and on Catalyst 3550 switch running
Release 12.1(8)EA1 or later. It is not available on the Catalyst 1900 and Catalyst 2820 switches.
To display a device popup menu, click an icon, and right-click.
Table 3-16 Device Popup Menu of a Cluster Icon
Popup Menu Option
Task
Expand cluster
View a cluster-specific topology view.
Properties
Display information about the device and port on either end of the link and the state of the link.
Table 3-17 Device Popup Menu of a Command-Switch Icon
Popup Menu Option
Task
Collapse cluster
View the neighborhood outside a specific cluster.
1
Host Name
Change the host name of a switch.
Bandwidth Graphs
Display graphs that plot the total bandwidth in use by the switch.
Properties
Display information about the device and port on either end of the link and the state of the link.
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
page
3-30.
Table 3-18 Device Popup Menu of a Member or Standby Command-Switch Icon
Popup Menu Option
1
Remove from Cluster
1
Host Name
2
Device Manager
Bandwidth Graphs
Properties
1. Available only from a cluster-management session.
2. Available from a cluster member switch but not from the command switch.
78-11380-04
Cluster
(Table
3-16)
Command switch
(Table
3-17)
Member or standby command switch
Candidate switch with an IP address
Candidate switch without an IP address
Neighboring devices
(Table
Task
Remove a member from the cluster.
Change the host name of a switch.
Launch Device Manager for a switch.
Display graphs that plot the total bandwidth in use by the switch.
Display information about the device and port on either end of the link and the state of the link.
(Table
3-18)
(Table
3-19)
(Table
3-20)
3-21)
Catalyst 2950 Desktop Switch Software Configuration Guide
Menus and Toolbar
"Access Modes in CMS" section on
3-23
Advertisement
Table of Contents
Troubleshooting
