Verifying The Configuration - Cisco 6500 Series Software Configuration Manual
Hide thumbs
Also See for 6500 Series:
- Configuration manual (392 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Configuring Local SPAN and RSPAN
When configuring monitor sessions, note the following syntax information:
•
•
•
•
When clearing monitor sessions, note the following syntax information:
•
•
This example shows how to configure Fast Ethernet port 5/48 as the destination for SPAN session 1:
Router(config)# monitor session 1 destination interface fastethernet 5/48
Verifying the Configuration
This example shows how to verify the configuration of session 2:
Router# show monitor session 2
Session 2
------------
Type : Remote Source Session
Source Ports:
Dest RSPAN VLAN:
Router#
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
34-12
single_interface is interface type slot/port; type is ethernet, fastethernet, gigabitethernet, or
tengigabitethernet.
interface_list is single_interface , single_interface , single_interface ...
In lists, you must enter a space before and after the comma. In ranges, you must enter a space
Note
before and after the dash.
interface_range is interface type slot/first_port - last_port
mixed_interface_list is, in any order, single_interface , interface_range , ...
Enter the no monitor session number command with no other parameters to clear
session session_number.
session_range is first_session_number-last_session_number
In the no monitor session range command, do not enter spaces before or after the dash. If
Note
you enter multiple ranges, do not enter spaces before or after the commas.
RX Only:
Fa3/1
901
Chapter 34
Configuring Local SPAN and RSPAN
78-14099-04
Advertisement
Table of Contents
Troubleshooting
