Chapter 37
Configuring the Switch Fabric Module
Configuring an LCD Message
To configure a message for display on the LCD, perform this task:
Command
Router(config)# fabric lcd-banner d message d
Router(config)# no fabric lcd-banner
When configuring a message for display on the LCD, note the following syntax information:
•
•
Monitoring the Switch Fabric Module
The Switch Fabric Module supports a number of show commands for monitoring purposes. A fully
automated startup sequence brings the module online and runs the connectivity diagnostics on the ports.
These sections describe how to monitor the Switch Fabric Module:
•
•
•
•
•
•
Note
The Switch Fabric Module does not require any user configuration.
Displaying the Module Information
To display the module information, perform this task:
Command
Router# show module {5 | 6 | 7 | 8}
78-14099-04
The d parameter is a delimiting character. You cannot use the delimiting character in the message.
The delimiter is a character of your choice—a pound sign (#), for example.
You can use the following tokens, in the form $(token), in the message text:
–
$(hostname)—Displays the switch's host name.
$(domain)—Displays the switch's domain name.
–
Displaying the Module Information, page 37-5
Displaying the Switch Fabric Module Redundancy Status, page 37-6
Displaying Fabric Channel Switching Modes, page 37-6
Displaying the Fabric Status, page 37-7
Displaying the Fabric Utilization, page 37-7
Displaying Fabric Errors, page 37-7
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Purpose
Configures a message for display on the LCD.
Clears the message displayed on the LCD.
Purpose
Displays module information.
Monitoring the Switch Fabric Module
37-5