Default Layer 2 Lan Interface Configuration - Cisco 6500 Series Software Configuration Manual
Hide thumbs
Also See for 6500 Series:
- Configuration manual (392 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
Chapter 7
Configuring LAN Ports for Layer 2 Switching
DTP is a point-to-point protocol. However, some internetworking devices might forward DTP frames
Note
improperly. To avoid this problem, ensure that LAN ports connected to devices that do not support DTP
are configured with the access keyword if you do not intend to trunk across those links. To enable
trunking to a device that does not support DTP, use the nonegotiate keyword to cause the LAN port to
become a trunk but not generate DTP frames.
Default Layer 2 LAN Interface Configuration
Table 7-3
Table 7-3
Feature
Interface mode:
•
•
Trunk encapsulation
Allowed VLAN range
VLAN range eligible for pruning
Default VLAN (for access ports)
Native VLAN (for 802.1Q trunks)
Spanning Tree Protocol (STP)
STP port priority
STP port cost
78-14099-04
shows the Layer 2 LAN port default configuration.
Layer 2 LAN Interface Default Configuration
Before entering the switchport command Layer 3 (unconfigured)
After entering the switchport command
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
Default Layer 2 LAN Interface Configuration
Default
switchport mode dynamic desirable
switchport trunk encapsulation negotiate
With Release 12.1(13)E and later releases,
•
VLANs 1 to 4094, except reserved VLANs (see
Table 9-1 on page
9-2)
•
With 12.1 E releases earlier than
Release 12.1(13)E, VLANs 1 to 1005
VLANs 2 to 1001
VLAN 1
VLAN 1
Enabled for all VLANs
128
100 for 10-Mbps Ethernet LAN ports
•
19 for 10/100-Mbps Fast Ethernet LAN ports
•
19 for 100-Mbps Fast Ethernet LAN ports
•
4 for 1,000-Mbps Gigabit Ethernet LAN ports
•
2 for 10,000-Mbps 10-Gigabit Ethernet LAN
•
ports
7-5
Advertisement
Table of Contents
Troubleshooting
