Vlan Configuration Guidelines And Restrictions; Restrictions; Guidelines; Configuring Vlans - Cisco 6500 Series Software Configuration Manual
Hide thumbs
Also See for 6500 Series:
- Configuration manual (392 pages) ,
- Configuration note (212 pages) ,
- Installation manual (194 pages)
Table of Contents
Advertisement
VLAN Configuration Guidelines and Restrictions
Table 9-6
Parameter
MTU size
Bridge number
STP type
VLAN state
VLAN Configuration Guidelines and Restrictions
Follow these guidelines and restrictions when creating and modifying VLANs in your network:
Restrictions
•
•
•
•
•
•
•
Guidelines
•
•
•
•
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
9-8
Token Ring (TrBRF) VLAN Defaults and Ranges (continued)
Supervisor engine redundancy does not support nondefault VLAN data file names or locations. Do
not enter the vtp file file_name command on a switch that has a redundant supervisor engine.
RPR+ redundancy (see
Chapter 5, "Configuring RPR and RPR+ Supervisor Engine
does not support a configuration entered in VLAN database mode. Use global configuration mode
with RPR+ redundancy.
You can configure extended-range VLANs only in global configuration mode. You cannot configure
extended-range VLANs in VLAN database mode. See the
on page
9-9.
The Cisco IOS end command is not supported in VLAN database mode.
You cannot enter Ctrl-Z to exit VLAN database mode.
Catalyst 6500 series switches do not support Token Ring or FDDI media. The switch does not
forward FDDI, FDDI-Net, TrCRF, or TrBRF traffic, but it can propagate the VLAN configuration
through VTP.
In a Token Ring environment, the logical interfaces (the connection between the TrBRF and the
TrCRF) of the TrBRF are placed in a blocked state if either of these conditions exists:
The TrBRF is running the IBM STP, and the TrCRF is in SRT mode.
–
The TrBRF is running the IEEE STP, and the TrCRF is in SRB mode.
–
Before installing a redundant supervisor engine, enter the no vtp file command to return to the
default configuration.
Before you can create a VLAN, the Catalyst 6500 series switch must be in VTP server mode or VTP
transparent mode. For information on configuring VTP, see
The VLAN configuration is stored in the vlan.dat file, which is stored in nonvolatile memory. You
can cause inconsistency in the VLAN database if you manually delete the vlan.dat file. If you want
to modify the VLAN configuration or VTP, use the commands described in this guide and in the
Catalyst 6500 Series Switch Cisco IOS Command Reference publication.
To do a complete backup of your configuration, include the vlan.dat file in the backup.
Default
VTPv1 1500; VTPv2 4472
1
ibm
active
Chapter 9
Configuring VLANs
Range
1500–18190
0–15
auto, ibm, ieee
active, suspend
Redundancy")
"VLAN Configuration Options" section
Chapter 8, "Configuring VTP."
78-14099-04
Advertisement
Table of Contents
Troubleshooting
